Finally, with a steel dedicated cotton buff, in a flex shaft or Dremel, polish them with whatever buffing compound you have on hand for polishing: rouge, white diamond, etc. If the dents are minor, you can use wet/dry 320 grit sandpaper then move up in number – up to 1000 grit. Tie back long hair, no dangling scarves, jewelry or sleeves and wear close-toed shoes. This is messy work so wear an apron! If you are using the sandpapers dry or are using power tools (including the flex shaft or Dremel), wear a mask and eye protection. But, if the inevitable happens, and you make dents, you can repair them. Of course, The easiest way to protect your hammer faces is to not hit steel with them. So, unless you like the look, make sure your hammer faces are REALLY shiny and smooth! Whatever is on the surface of the hammer will transfer to the metal. But, you don’t want hammers that are used for forming to look like this. This is how these hammer heads eventually look, with use. Wipe the faces with an oiled rag after use to remove dirt, grease and grit.Ĭhasing & Repousse hammer after use. In damp climates or in general, make little covers from old towels, oil them with 3-in-one oil and hold the rag onto the hammer head with an elastic band. How do I keep these polished? What tools do I need to buff out any marks? Would a belt sander like this from Harbor Freight do the job? Also I would like to polish my steel blocks.įor general care of steel tools you’ll want to oil them once in a while to keep the rust down. My concern is keeping them polished so as not to transfer marks on to the metal. I bought myself some of the Fretz hammers recently. Nancy LT Hamilton Questions and Answers How to Finish My Steel Tools
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |